B&C Technologies DI-325 Industrial - Manual (Page 50)

OPERATING AND PROGRAMMING INSTRUCTIONS
8-19
When cause of the alarm has been corrected, the alarm can be reset with the START button.
After that, ‘Waiting for cycle restart’ will be displayed. The same will happen if the STOP button is
pushed once.
If the message ‘Waiting for cycle restart’ is displayed, the cycle can be restarted with the
START button and the pause situation is cancelled. If, in this case, the STOP button is pushed, the
complete program will be cancelled and the step described in chapter 5.1 is activated.
When the drying step and the cool-down step are finished, the step described in chapter 5.4
is activated.
5.4 Program completed
This step is activated when a program cycle is finished. When the program cycle is
completed, the beeper will sound for the time defined in machine parameter 6 (see chapter 6.4.3).
This beeper sound will restart every 2 minutes.
After finishing a program the machine will either stop or the anti-crease cycle will start if
this is selected. The anti-crease function can be enabled or disabled in the program parameters (see
chapter 6.4.1).
If anti-crease is enabled the machine will be stopped for 2 minutes after finishing a program
cycle. After 2 minutes, anti-crease starts. This means that the drum direction and speed as defined in
the program will be used and the blower will be off.
NOTE: Because the blower output is off during anti-crease operation, the anti-crease function will
not work if the blower and the drum motor are both connected to output 7 during
installation of the controller.
If a cycle is completed, the dryer will stay in this step (audible signal and/or anti-crease
operation) until the door is opened. When the door is opened, the controller assumes the dryer will
be emptied and will go back to the ‘ready to start’ state as described in chapter 5.1.
6. Menu structure
If a parameter setting needs to be changed, a counter needs to be read or reset or test
programs need to be run, these items can all be accessed via the main menu.
The main menu can be accessed by pushing the set-up button in the main screen. The set-up
button is the SHIFT button in combination with the HOME button.
Press the SHIFT and HOME button combination and the main menu will be displayed.
Items can be selected from the menu by using the ARROW UP and/or ARROW DOWN button.
Confirming the choice of an item is done by pressing the ENTER button. Some items give direct
access to functions, some items will open another menu. The menu tree is as follows: