Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI - Manual (Page 223)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI 6-17
Voice over IP
Phone Settings
Field Definition
Identification
Begin Line Number Displays the line number that was selected to edit.
End Line Number Specifying a line number here allows a user to define a range to apply
the settings to. Settings will be applied to all the lines between “begin
line number” and “end line number”.
User ID Display/Edit the current User ID. Note: A maximum of 20 characters
is allowed.
Cross Connect Name This field appears for the MSR only.
Description Display/Edit the line description. Use the display name for Caller ID.
Packet Processing
Codec Pref1 Codec preferences are used to establish the codec list offered during
media negotiation. Pref1 is the first codec, followed by pref2 and
pref3.
Select the first codec preference.
Codec Pref2 Select the second codec preference.
Codec Pref3 Select the third codec preference.
Fax Mode None - A Fax call would be treated as a normal voice call. Default.
Bypass - Causes the line to transmit in G.711 mode, with silence
suppression disabled, on detection of Fax tone.
Modem/SuperG3 Fax
Mode None - A Modem call would be treated as a normal voice call.
Default.
Bypass - Causes the line to transmit in G.711 mode, with echo
cancellation and silence suppression disabled, on detection of
Modem tone.
Silence Suppression Select to enable Silence suppression on the line.
Jitter Buffer Set Jitter Buffer from the pulldown menu.
Static - Maintain a static average delay, through the jitter buffer.
Default.
Dynamic - Specify dynamic delay adjustment to minimize delay
through the jitter buffer.
Voice Processing
Transmit Gain Set transmit gain. Range -12 to +6.
Transmit direction is from the Adit towards FXS.
Receive Gain Set receive gain. Range -12 to +6.
Transmit direction is from the FXS towards the Adit.
Impedance Set the impedance from the pulldown menu.
Note: Not supported by the MSR. (Impedance is handled by the
Adit 600 controller or card.)
Echo Cancellation Select to enable Echo Cancellation on the lines.