Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI - Manual (Page 117)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI 3-7
Network Connections
Preconfigured Connections
NOTE: For a manually specified network mode (Internet Protocol: Use the following IP address), the
default route does not get installed until both the Default Route checkbox is enabled AND the user has
entered a valid non-0.0.0.0 Gateway IP in the Default Gateway field.
IP Address Distribution (This name is a link to the Advanced/IP Address Distribution (DHCP)
window.)
Disabled Disables this feature.
DHCP Server Configures DHCP Server.
Start IP Address - Client address pool starting address
End IP Address - Client address pool ending address
Subnet Mask - Subnet mask of the Start/End IP address listed above.
WINS Server IP Address - Windows Internet Name
Service Server IP address.
Lease Time In Minutes - lease during the DHCP
server applies to the client assignments.
Provide Host Name if Not Specified by Client - Select to enable.
DHCP Relay New IP Address - The address of the DHCP Relay Server.
DHCP Options Opens a window that configures the DHCP options per RFC 2132. See
Configuring DHCP Options on page 3-8.
Routing (This name is a link to the Advanced/Routing window)
Routing Mode Displays the current routing mode.
Device Metric Value of Metric of IP network on this interface in Routing Table. Range is 0-
255.
Default Route Check to enable default route.
Proxy ARP -
Ethernet ARP Proxy Check to enable Proxy ARP.
Routing Protocol None - Disable the routing protocol on this interface.
OSPF - Set the routing protocol to OSPF on this interface. There is a link
below the option to configure OSPF.
RIP - Set the routing protocol to RIP on this interface.
Listen to RIP Messages - None, RIPv1, RIPv2, RIPv1/2
Send RIP Messages - None, RIPv1, RIPv2 - Broadcast, RIPv2 - Multicast
Internet Connection
Firewall Note: This name is a link to the Security window.
Enables/Disables Firewall for this device.
Allow Unrestricted
Administration Note: This name is a link to the Security window.
Enables/disables unrestricted administration.
Additional IP
Addresses New IP Address - Opens a window to assign an additional IP address to this
device.
Field Definition (Continued)