Weiser SmartCode5 - Traditional & Contemporary - Manual (Page 6)

1 2
3 4
5 6
7 8
9 0
How the keypad works:
Each button represents two numbers (i.e. 1 and 2 for the first button). You
only need to push the button once to get either 1 or 2. For example: If
your code is 1-2-5-6-8,
■ Press the
1 2
button once to get number 1.
■ Press the
1 2
button once to get number 2.
■ Then press the
5 6
button once to get number 5.
■ Then press the
5 6
button once to get number 6.
■ Finally press the
7 8
button once to get number 8.
1 2
3 4
5 6
7 8
9 0
6
b. Note that the turnpiece is functioning properly when it is slightly away from
the vertical position when locked or slightly away from a horizontal position
when unlocked.
8. Continued.......
a. Press the program button on the interior unit once.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the “LOCK” button to save code.
d.
9. Programming a User Code.
● A programmed code can be from four (4) to eight (8) digits long.
● For maximum security an 8 digit code is recommended.
● Up to 2 user codes can be entered.
● Excess delay in the programming steps once started will cause unit to
beep twice and will require you to restart from step (9a) below.
Programming the 1st user code.
Extend the bolt by pressing the “LOCK” button and re-enter the code
to test. The bolt should retract to the unlocked position. If it does not
unlock, repeat steps (a) through (c).
LOCKED LOCKED UNLOCKED UNLOCKED
TURNPIECE TURNPIECE
Program
Button
LOCK
Button
Continued