Rice Lake 920i USB Installation Manual V5.05 - Manual (Page 72)

66 920i Installation Manual
6.6 Saving Configuration Files and
Databases
Certain files may take extended periods of time to save
directly from a PC to the
920i . For fastest save times,
using a Flash drive is recommended.
07/01/2011 01:57PM
Save Configuration (*.920)
Save All Databases (*.db)
Drive
No Device
USB
Scale #
Scale
#
Note
Note
When saving a configuration file, the
indicator will attempt to save to a folder
matching its UID number (the default
UID# is 1). If no such folder is found, the file will be saved
to the drive’s root directory and overwrite any existing files
matching its UID# followed by the .920 file extension i.e.,
1.920i.
Important
When the 920i saves a database, it will use the
alias name and a .db file extension.
1. Connect the flash drive to the 920i ’s type-A
USB port.
2. With the indicator in weigh mode, press the
USB softkey.
If the USB softkey is not displayed, see
Section 1.3 on page 4 and Figure 3-13 on
page 44 to enable the softkey.
3. Select Save Configuration (*.920) or Save All
Databases (*.db) and press ENTER .
Figure 6-6. Save Configuration menu*
6.7 Loading New Firmware
P r i o r t o l o a d i n g n e w f ir m w a r e , s a v e e x i s t i n g
c o n f i g u r a t i o n a n d / o r d a t a b a s e s b y u s i n g t h e
instructions in Section 6.6.
1. Using a PC, copy the boot monitor (ipl.run)
and firmware (920i.run) files to a flash drive.
2. Disconnect power and engage the SW1
jumper.
3. Connect the flash drive to the indicator and
reconnect power. The following message will
appear.
System Diagnostic Monitor v2.03, 920i
loading...
jumper enabled
checking for connected devices...
USB Interface Board
checking for firmware update...
loading ipl.run boot monitor. Please wait...
******
finishing load
erasing FLASH boot sectors...
writing to FLASH
Note
The unit resets at this point.
System Diagnostic Monitor v2.03, 920i
loading...
jumper enabled
checking for connected devices...
USB Interface Board
checking for firmware update...
updating boot loader
erasing FLASH boot sectors...
writing to FLASH...
DONE
cycle power to restart boot monitor
After power cycle:
System Diagnostic Monitor v2.03, 920i
loading...
jumper enabled
checking for connected devices...
USB Interface Board
USB Interface V1.01 On-Line:
checking for firmware update...
loading 920iPLUS.run boot monitor. Please wait...
*******************************
finishing load
erasing FLASH blocks...
writing data to FLASH...
DONE
file load complete
resetting configuration
4. Disconnect power, remove the SW1 jumper,
and reconnect power