Rice Lake 920i USB Installation Manual V5.05 - Manual (Page 103)

Serial Commands 97
SC.TER.DECPNT#n Tertiary units decimal position 8.888888, 88.88888, 888.8888, 8888.888, 88888.88, 888888.8,
8888888, 8888880, 8888800
SC.TER.DSPDIV#n Tertiary units display divisions 1D, 2D, 5D
SC.TER.MULT#n Tertiary units multiplier 0.000001–9999999
SC.ROC.DECPNT#n Tertiary units decimal position 8.888888, 88.88888, 888.8888, 8888.888, 88888.88, 888888.8,
8888888, 8888880, 8888800
SC.ROC.DSPDIV#n Rate-of-change units display
divisions 1D, 2D, 5D
SC.ROC.MULT#n Rate-of-change units multiplier 0.000001–9999999
SC.ROC.UNITS#n Rate-of-change units SEC, MIN, HOUR
SC.ROC.INTERVL#n Rate-of-change interval 1–100
SC.ROC.REFRESH#n Rate-of-change refresh
interval 0.1–60
SC.RANGE1.MAX#n Weight maximum for first
range or interval weight
SC.RANGE2.MAX#n Weight maximum for second
range or interval weight
SC.RANGE3.MAX#n Weight maximum for third
range or interval weight
SC.ACCUM#n Accumulator enable ON, OFF
SC.VISIBLE#n Scale visibility ON, OFF
SC.PEAKHOLD#n Peak hold OFF, NORMAL, BI-DIR, AUTO
SC.WZERO#n Zero calibration —
SC.WVAL#n Test weight value test_weight_value
SC.WSPAN#n Span calibration —
SC.WLIN.F1#n–
SC.WLIN.F5#n Actual raw count value for
linearization points 1–5 0–16777215
SC.WLIN.V1#n–
SC.WLIN.V5#n Test weight value for
linearization points 1–5 0.000001–9999999
SC.WLIN.C1#n–
SC.WLIN.C5#n Calibrate linearization points
1–5 —
SC.LC.CD#n Deadload coefficient —
SC.LC.CW#n Span coefficient —
SC.LC.CZ#n Temporary zero —
SC.REZERO#n Rezero —
For commands ending with “#n”, n is the scale number.
Command Description Values
Table 10-4. SCALES Serial Commands (Continued)