Rice Lake 920i USB Installation Manual V5.05 - Manual (Page 108)

Table 10-9. DIG I/O Serial Commands
Command Description Values
DON.b#s Set digital output on (active) at bit b, slot s. —
DOFF.b#s Set digital output off (inactive) at bit b, slot s. —
DIO.b#s Digital input function OFF, INPUT, OUTPUT, PROGIN, ZERO, NT/GRS,
TARE, UNITS, PRINT, ACCUM, SETPNT,
TIMDATE, ESC, CLEAR, DSPTAR, IDKEY,
KEY0–KEY9, KEYDP, ENTER, NAVUP, NAVDN,
NAVLFT, NAVRGT, KBDLOC, HOLD, BATRUN,
BATSTRT, BATPAUS, BATRESET, BATSTOP,
CLRCN, GROSS, NET, PRIM, SEC, CLRTAR,
CLRACC, TRIGGER
DIO.TRIG_SLOT.b#s Trigger output slot NONE, SLOT3
DIO.TRIG_PARAM.b#s Trigger output parameter value
Digital inputs and outputs are specified by bit number (b) and slot number (s)
Table 10-10. ALGOUT Serial Commands (Valid Only If Analog Output Card Is Installed)
Command Description Values
ALG.ALIAS#s Analog output alias name
ALG.SOURCE#s Analog output source PROG, SCALEn
ALG.MODE#s Mode GROSS, NET
ALG.OFFSET#s Zero offset 0%, 20%
ALG.ERRACT#s Error action FULLSC, HOLD, ZEROSC
ALG.MIN#s Minimum value tracked 0–9999999
ALG.MINNEG#n Minimum value is negative OFF, ON
ALG.MAX#s Maximum value tracked 0–9999999
ALG.MAXNEG#n Maximum value is negative OFF, ON
ALG.ZERO#s Zero calibration 0–65535
ALG.SPAN#s Span calibration 0–65535
For commands ending with “#s”, s is the slot number. For dual-channel analog output cards,channel 2 is assigned to
ALGOUTs+14. For example, channel 2 of a dual analog output card in Slot 3 is assigned ALGOUT17.
Table 10-11. FLDBUS Serial Commands (Valid Only If Fieldbus Card Is Installed)
Command Description Values
FB.BYTESWAP#s Swap data bytes NONE, BYTE, WORD, BOTH
FB.SIZE#s Number of bytes to transfer 2–128
For commands ending with “#s”, s is the slot number.
Table 10-12. Analog Input Serial Commands (Valid Only If Analog Input Card Is Installed)
Command Description Values
XP#s Extract probe temperature —
XPP#s Extract probe primary temperature
XPS#s Extract probe secondary temperature
XPT#s Extract probe tertiary temperature
XI#s Extract 0–20 mA value
XV#s Extract 0–10 V value
For commands ending with “#s”, s is the slot number.
102 920i Installation Manual