Rice Lake 920i USB Installation Manual V5.05 - Manual (Page 105)

Serial Commands 99
DECFMT Decimal format DOT, COMMA
DSPRATE Display rate 1–80, in100-ms intervals
CONSNUM Consecutive numbering 0–9999999
CONSTUP Consecutive number start-up value 0–9999999
UID Unit identifier aaaaaaaa (up to 8 alphanumeric characters)
TRUCK Truck in/out mode OFF, MODE1, MODE2, MODE3, MODE4, MODE5, MODE6
ALIBI Alibi data storage OFF, ON
CONTRAST Adjusts the contrast level 0–127
CFGPWD Configuration password 0, 1–9999999
SPPWD Setpoint password 0, 1–9999999
SK#1–SK#32 Softkey assignment Blank, TimeDate, DspTar, DspAcc, DspROC, SetPt, BatStrt,
BatStop, BatPause, BatRst, WeighIn, WeighOut, TrkReg, UID,
SclSel, Diagnostics, Alibi, Contrast, Test, Stop, Go,
SKUD1–SKUD10
SKT#1–SKT#10 User-defined softkey text —
KYBDLK Keyboard lock (disable keypad) OFF, ON
ZERONLY Disable all keys except ZERO OFF, ON
PROMPT#1–
PROMPT#60 Prompts/setpoint names —
REGULAT Regulatory compliance NONE, OIML, NTEP, CANADA, INDUST
REG.SNPSHOT Display or Scale weight source DISPLAY, SCALE
REG.HTARE Allow tare in display hold NO, YES
REG.ZTARE Remove tare on ZERO NO, YES
REG.KTARE Always allow keyed tare NO, YES
REG.MTARE Multiple tare action REPLACE, REMOVE, NOTHING
REG.NTARE Allow negative tare NO, YES
REG.CTARE Allow clear keyed tare NO, YES
REG.CHILDZT Clear child scales individually NO, YES
REG.NEGTOTAL Allow total scale to display negative
value NO, YES
REG.PRTMOT Allow print while in motion NO, YES
REG.PRINTPT Add PT to keyed tare print NO, YES
REG.PRTHLD Print during display hold NO, YES
REG.HLDWGH Allow weighment during display
hold NO, YES
REG.MOTWGH Allow weighment in motion NO, YES
REG.OVRBASE Zero base for overload calculation CALIB ZERO, SCALE ZERO
REGWORD Regulatory word GROSS, BRUTTO
CONTACT.COMPANY Contact company name company_name (up to 30 characters)
CONTACT.ADDR1
CONTACT.ADDR2
CONTACT.ADDR3 Contact company address company_address (up to 30 characters for each line)
CONTACT.NAME1
CONTACT.NAME2
CONTACT.NAME3 Contact names contact_names (up to 20 characters each)
Command Description Values
Table 10-6. FEATURE Serial Commands (Continued)