Rice Lake 920i USB Installation Manual V5.05 - Manual (Page 132)

126 920i Installation Manual
11.11 Audit Trail Support
Audit trail support provides tracking information for
configuration and calibration events. A separate
calibration counter is provided for each scale; a single
configuration counter tracks all configuration changes.
To prevent potential misuse, unsaved configuration or
calibration changes are counted as change events;
restoration of the previous saved configuration or
calibration is also counted.
11.11.1 Displaying Audit Trail Information
To display audit trail information, press and hold the
Gross/Net key for several seconds. Various audit trail
information screens can then be accessed by pressing
the front panel number keys (
1–7 and 0 ). The exact
format of each screen depends on the regulatory
agency specified for the REGULAT (FEATURE menu)
parameter.
The initial screen shown when entering the audit trail
display (or whenever the
1 key is pressed while
showing audit trail information) shows the legally
relevant (LR) version number (software version for the
code that provides audit trail information), a calibration
count and, if REGULAT=NTEP, a configuration count.
Press 2 to show the configuration count display. This
display shows the number of times the system has been
configured, the date and time of the last configuration
event, and the before and after information for the most
recent change of the system date and time.
Press the Down key to show the number of weighments,
n u m b e r o f c o n f i g u r a t i o n e v e n t s , n u m b e r o f
calibrations, and the date and time of the most recent
calibration for the first configured scale. Continue
pressing the
Down key to cycle through the information
for all configured scales.
Press 3 to show the number and the most recent date
and time of power-on events, power-on configuration
changes, and user program loads.
Use the Down key to show the number of power-on
calibration events for all configured scales.
Press 4 to show the number of times the OEM version
number has been changed, and the date and time of the
most recent change.
Press 5 to show the number of times the configuration
has been reset, the date and time of the most recent
reset, and the indicator EIN number.
Press 6 to show the manufacturer of the indicator.
Press 7 to show the number of core loads, and the date
and time of the most recent.
Press 0 to show the indicator and LR software versions.
When done, press the Gross/Net key to exit the audit
trail displays.
11.11.2 Printing Audit Trail Information
Audit trail information can be printed by pressing the
PRINT key while displaying the audit trail or by sending
the DUMPAUDIT serial command. Audit trail
information is sent to the port specified on the
AUD.PORT serial command or by the AUDFMT
parameter (PFORMT menu).
Note
Printed audit trail information contains data for
all scales, whether configured or not, that can
be supported by the indicator. Displayed audit
trail information shows data only for currently
configured scales.
long tons 2240.00 pounds
1016.05 kilograms
1.12000 short tons
1.01605 metric tons
troy ounces 480 grains
31.10348 grams
0.031103 kilograms
1.09714 ounces
0.068571 pounds
0.083333 troy pounds
troy pounds 5760 grains
373.2417 grams
0.373242 kilograms
13.16571 ounces
0.822857 pounds
12 troy ounces
Primary Unit x Multiplier
Secondary/
Tertiary Unit
Table 11-12. Conversion Factors (Continued)