Rice Lake 920i USB Installation Manual V5.05 - Manual (Page 14)

8 920i Installation Manual
supported by the alibi feature. The feature is
enabled using the ALIBI parameter on the
FEATURE menu; print transactions can be recalled
by assigning an
Alibi softkey, also configured using
the FEATURE menu (see Section 3.2.3 on page 44).
• New IMAGE parameter on the FEATURE menu
allows inversion of the display image
(blue-on-white or white-on-blue) for support of the
outdoor display option. See Section 3.2.3.
• Display and printing of audit trail information is
described in Section 11.11 on page 126.
Version 3.00
• The desktop model of the 920i has been
discontinued. Drawings and parts lists for the
desktop model have been removed from this
manual.
• Added support for multi-range and multi-interval
scale configurations.
• Zero tracking, zero range, and motion band
parameters (SCALES menu) have been changed to
allow numeric values.
• Added peak hold function to SCALES menu.
• Added last zero and temporary zero functions to
calibration menus to allow recalibration based on
previous zero values.
• Enhanced print formatting with addition of audit
format and twenty auxiliary formats.
• The SERIAL menu has been restructured to provide
additional parameters for configuring RS-485
communications. See Figure 3-12 on page 40.
• A new digital input count (DINCNT) setpoint, used
to count digital input pulses, has been added to the
supported setpoint kinds. See Section 9.0 on
page 75.
• A SENSE parameter has been added to optionally
invert the value of setpoint digital outputs. See
Section 9.0 on page 75.
• TRIGGER (digital output trigger) has been added as
a selection under the DIG I/O menu (see
Section 3.2.6 on page 52) for custom applications.
• Support has been added for EtherNet/IP and analog
input/thermocouple option cards.
1.8 Hardware and Software
Compatibility
• CPU board revision A-D was the initial release and
covered versions 1 and 2.
• Revision E was the release of version 3 which had a
minimum CPU revision, increasing memory.
• Revisions F-G used the final version of the old CPU
hardware build.
• Revision H boards are of the new design for the
replacement of PN 67612. The new CPU board is
PN 109549 and requires a minimum core of
3.14.00.
Important Information Regarding Your 920i CPU Board
Because select components of the 920i CPU have
recently become obsolete, certain design changes have
become unavoidable. Therefore, please be aware that
beginning with Revision H, the CPU board will support
only firmware 3.14 or higher. This does not affect any
pre-existing user programs, and any performance
issues should immediately be brought to the attention
of Rice Lake Weighing Systems.
Table 1-7. Hardware and Software Compatibility
CPU Board
Revision
Recommended
Boot Monitor Minimum Core
Maximu
m Core
Minimum USB
Version
A-D 1.00 1.00.00 2.08.00 N/A
E 1.10 1.00.00 4.00.00 N/A
F-G 1.12 1.00.00 5.XX.00* N/A
H 1.13 3.14.00 5.XX.00* N/A
L** 2.03 5.00.00 5.XX.00* 1.01
* Refer to current release version
** USB Board