Rice Lake 920i USB Installation Manual V5.05 - Manual (Page 107)

Serial Commands 101
SP.START#n Starting setpoint 1–100
SP.END#n Ending setpoint 1–100
SP.DISLOT#n Digital input slot NONE, SLOTx
SP.MASK#n Digital input mask number
SP.NSAMPLE#n Number of samples number
SP.TIME#n Trip time hhmm
SP.DURATION#n Trip duration hhmmss
SP.VUNDER#n Underrange value number
SP.VOVER#n Overrange value number
SP.DUNDER#n Underrange digital output BITx
SP.DACCEPT#n Accept digital output BITx
SP.DOVER#n Overrange digital output BITx
BATCHNG Batching mode OFF, AUTO, MANUAL
SP.ENABLE#n Setpoint enable ON, OFF
For setpoint commands ending with “#n”, n is the setpoint number.
Table 10-8. PFORMT Serial Commands
Command Description Values
GFMT.FMT
GFMT.PORT Gross demand print format string For .PORT commands, specify the port number as PORTxx (no
leading zero). For example: GFMT.PORT=PORT3.
For AUXFMT.FMT and .PORT commands, specify the auxiliary
format number (1—20) as .FMT#nn or .PORT#nn (no leading zero).
For example: AUXFMT.FMT#8=GROSS...
See Section 7.0 on page 67 for information about demand print
format strings.
See the iQUBE 2 Installation Manual, PN 106113, for more
information about alert formats.
NFMT.FMT
NFMT.PORT Net demand print format string
ACC.FMT
ACC.PORT Accumulator print format string
SPFMT.FMT
SPFMT.PORT Setpoint print format string
TRWIN.FMT
TRWIN.PORT Truck weigh-in print format string
TRWOUT.FMT
TRWOUT.PORT Truck weigh-out print format string
TR.FMT
TR.PORT Truck register print format string
ALERT.FMT
ALERT.PORT Alert format string
HDRFMT1
HDRFMT2 Ticket header format strings
AUXFMT.FMT#nn
AUXFMT.PORT#nn Auxiliary ticket format
AUD.PORT Audit trail port
WDGT#n Display widget widget_number
See Section 10.2 on page 107 for widget programming information.
WDGT.CLR Clear widgets —
Command Description Values
Table 10-7. SETPNTS Serial Commands (Continued)