Rice Lake 920i USB Installation Manual V5.05 - Manual (Page 122)

116 920i Installation Manual
11.3 Keyboard Interface
11.3.1 Serial Interface
Serial port 2 on the 920i CPU board provides a
PS/2-type keyboard interface for use with a remote
keyboard. To use the keyboard interface, set the INPUT
parameter for Port 2 (under the SERIAL menu) to
KEYBD .
Table 11-6 summarizes the 920i-specific functions
provided by the keyboard interface; most other
alphanumeric and navigational keys provide functions
equivalent to those typical for PC operation. Menu
parameters and serial commands that affect indicator
k e y p a d o p e r a t i o n ( i n c l u d i n g t h e K B D L C K ,
ZERONLY, and KLOCK serial commands) also affect
the remote keyboard.
Note
• The keyboard interface is not hot-pluggable.
Disconnect power to the 920i before plugging
the keyboard cable into the Port 2 connector.
• The 920i supports keyboard scan codes 1, 2,
and 3.
11.3.2 USB Interface
The 920i USB interface board provides a type-A
connection for a USB keyboard interface. To use the
keyboard interface, set the DEVICE parameter for Port
2 (under the SERIAL menu) to
KEYBOARD .
Table 11-6 summarizes the 920i-specific functions
provided by the keyboard interface; most other
alphanumeric and navigational keys provide functions
equivalent to those typical for PC operation. Menu
parameters and serial commands that affect indicator
k e y p a d o p e r a t i o n ( i n c l u d i n g t h e K B D L C K ,
ZERONLY, and KLOCK serial commands) also affect
the remote keyboard.
Table 11-6. PS/2 Keyboard Functions
Key Function
F1 Softkey 1
F2 Softkey 2
F3 Softkey 3
F4 Softkey 4
F5 Softkey 5
F6 (Alt+Z) ZERO key
F7 (Alt+G) GROSS/NET key
F8 (Alt+T) TARE key
F9 (Alt+U) UNITS key
F10 (Alt+P) PRINT key
F11 Not used
F12
Print Screen Same as PRINT key, in both
normal and setup modes
PRTMOT Allow print while in motion NO NO NO NO YES
PRTPT Add PT to keyed tare print NO NO YES YES NO
PRTHLD Print during display hold NO NO NO NO YES
HLDWGH Allow weigh during display hold NO NO NO NO YES
MOTWGH Allow weighment in motion NO NO NO NO NO
OVRBASE Zero base for overload calculation CALIB
ZERO
CALIB
ZERO
CALIB
ZERO
SCALE
ZERO
CALIB
ZERO
REGULAT / INDUST Parameter REGULAT Mode
Parameter Name Text Prompt INDUST NTEP CANADA OIML NONE
Table 11-5. REGULAT / INDUST Mode Parameters, Comparison with Effective Values of Other Modes (Continued)