Navigat ion, Route guidance – Mercedes-Benz C-Coupe 2012 COMAND Manual User Manual
Page 83
X
To show the menu: press W the COMAND
controller.
X
Select
Navi
in the main function bar by
sliding ZV the COMAND controller and
press W to confirm.
X
Select
Announce Street Names
and press
W to confirm.
Depending on the previous status, the
function is switched on O or off ª.
Canceling or continuing route
guidance
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Select
Dest.
in the navigation system
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
X
To cancel route guidance: select
Cancel
Route Guidance
and press W to confirm.
or
X
To continue route guidance: select
Continue Route Guidance
and press W
to confirm.
COMAND calculates the route.
Destination or area of destination
reached
When you reach your destination, COMAND
displays a checkered flag and route guidance
is automatically ended.
If the destination is not in close proximity to
a digitized street, the
Area of
destination reached
message appears
when the destination is reached.
Navigation announcements
Repeating navigation announcements
G
WARNING
Navigation announcements are intended to
direct you while driving without diverting your
attention from the road and driving.
Please always use this feature instead of
consulting the map display for directions.
Consulting the symbols or map display for
directions may cause you to divert your
attention from driving and increase your risk
of an accident.
i
Audible navigation announcements are
muted during a telephone call.
If you have missed an announcement, you can
call up the current announcement at any
time.
X
To show the menu: press W the COMAND
controller.
X
Select
RPT
in the navigation system menu
bar by turning cVd the COMAND
controller and pressing W to confirm.
Switching navigation announcements
on/off
X
To switch off: press the 8 button
during an announcement.
You will briefly see the message:
The
driving instructions have been
muted
.
X
To switch on: press W the COMAND
controller.
X
Select
RPT
in the navigation system menu
bar by turning cVd the COMAND
controller and pressing W to confirm.
i
COMAND automatically switches the
navigation announcements back on when:
R
you have a new route calculated.
R
you switch COMAND back on again or
start the engine.
Route guidance
81
Navigat
ion
Z