Na vigation, Destination entry – Mercedes-Benz C-Coupe 2012 COMAND Manual User Manual
Page 64
X
To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears.
X
Turn cVd until the desired scale is set.
Turning clockwise zooms out from the map;
turning counter-clockwise zooms in.
X
To select a destination: press W the
COMAND controller once or several times.
You will see either the address entry menu
with the destination address or, if COMAND
is unable to assign a unique address, a
selection list.
X
Select a destination by turning cVd the
COMAND controller and press W to
confirm.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
see the entry
Destination From Map
.
X
To start route calculation: select
Start
and press W to confirm.
Entering a destination using geo-
coordinates
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Select
Destination
in the navigation
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Select
Using Geo-Coordinates
and
press W to confirm.
An entry menu appears.
You can now enter the latitude and longitude
coordinates.
X
To change a value: turn cVd the
COMAND controller.
X
To move the mark within the line: slide
XVY the COMAND controller.
X
To move the mark between the lines:
slide ZVÆ the COMAND controller.
X
To confirm the value: press W the
COMAND controller.
i
If the selected position is outside the
digital map, COMAND uses the nearest
digitized road for route calculation. You will
see the
The position is off the map
message. If the selected position is located
over a body of water, you will see the
message:
The destination is in a
body of water. Please select
another destination.
Entering an intermediate stop
Introduction
You can use this function to enter an
intermediate stop while the vehicle is in
motion. COMAND provides a selection of
62
Destination entry
Na
vigation