Mercedes-Benz C-Coupe 2012 COMAND Manual - Manual (Page 108)

Option 1: the menu appears
X Select Using Map , From Memory or From
Personal POIs and press W to confirm.
If you select Using Map , the map with the
crosshair appears.
After choosing between
From Memory or
From Personal POIs , either the
destination memory (
Y
page 94) or the list
of categories for personal points of interest
appears (
Y
page 75).
X Choose the destination or personal point of
interest and press W to confirm.
X
If the destination address is displayed,
select Continue and press W to confirm.
The map appears.
The crosshair marks the center of the area
that is to be avoided.
X To move the map: slide XVY, ZVÆ or
aVb the COMAND controller.
X
To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears. Turning clockwise zooms out from
the map; turning counter-clockwise zooms
in.
X Turn cVd until the desired scale is set.
X To apply a block: press W the COMAND
controller.
A red square appears on the map.
X To adjust the size of the square: turn
cVd the COMAND controller.
The square is enlarged or reduced.
X To confirm the settings: press W.
The list appears. The previously selected
area to be avoided has been added and
activated.
X
Follow the instructions listed under "Option
2: the list appears".
Option 2: the list appears
"Avoid area" list (example)
i Available list places are named Area
and are shown in gray.
X Select Avoid New Area by turning cVd
the COMAND controller and press W to
confirm.
A menu appears.
106
Additional settings
Na
vigation