Na vigat ion, Destination entry – Mercedes-Benz C-Coupe 2012 COMAND Manual User Manual
Page 66
Deleting an intermediate stop
If an intermediate stop has already been
entered, you can delete it.
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Select
Destination
in the navigation
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Select
Stopover
and press W to confirm.
X
Select
Delete Stopover
and press W to
confirm.
COMAND deletes the intermediate stop
and recalculates the route to the main
destination.
Entering waypoints
Introduction
You can map the route yourself by entering
up to two waypoints. The sequence of the
waypoints can be changed at any time.
i
An intermediate stop is always between
the current position of the vehicle and the
first waypoint.
Creating waypoints
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Select
Dest.
in the navigation system
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
X
Select
Intermediate Destinations
and
press W to confirm.
The destination is entered in the menu.
Waypoint menu without waypoints
X
Confirm the symbol for waypoint 1 by
pressing W the COMAND controller.
X
Confirm
Set
by pressing W the COMAND
controller.
X
Enter the waypoint via one of the following
options.
Selection
Step
Address Entry
X
Enter a
destination by
address
(
Y
page 54).
From Memory
X
Select a
destination from
the destination
memory
(
Y
page 60).
From Last
Destinations
X
Select a
destination from
the list of last
destinations
(
Y
page 61).
64
Destination entry
Na
vigat
ion