Kontron TIGW1U Carrier Grade Server User Manual
Kontron carrier grade server tigw1u
Table of contents
Document Outline
- 1 December 2009Introduction
- 2 Features
- 3 Server Installations and Upgrades
- 3.1 Before You Begin
- 3.2 General Installation Procedures
- 3.3 Hot-Swappable Component Installation Procedures
- 3.4 Internal System Component Installation Procedures
- 3.5 Internal System Component Replacement Procedures
- 3.5.1 Replacing an Optical Device
- 3.5.2 Replacing a Fan Assembly
- 3.5.3 Replacing the SAS Front Panel Board
- 3.5.4 Installing the Intel® Remote Management Module 2
- 3.5.5 Replacing the Power Distribution Board
- 3.5.6 Replacing the Server Board
- 3.5.7 Replacing the CMOS Battery on the Server Board
- 3.5.8 Installing the Battery Insulator
- 3.6 Installing the Server into a Rack
- 4 Server Utilities
- 5 Troubleshooting
- 5.1 Resetting the System
- 5.2 Problems Following Initial System Installation
- 5.3 Hardware Diagnostic Testing
- 5.4 Specific Problems and Corrective Actions
- 5.4.1 Power Light does not Light
- 5.4.2 No Characters Appear on Screen
- 5.4.3 Characters are Distorted or Incorrect
- 5.4.4 System Cooling Fans do not Rotate Properly
- 5.4.5 Cannot Connect to a Server
- 5.4.6 Diagnostics Pass but the Connection Fails
- 5.4.7 The Server Hangs When the Drivers are Loaded
- 5.4.8 The Controller Stopped Working When an Add-in Adapter was Installed
- 5.4.9 The Add-in Adapter Stopped Working Without Apparent Cause
- 5.4.10 System Boots When Installing a PCI Card
- 5.4.11 Problems with Newly Installed Application Software
- 5.4.12 Problems with Application Software that Ran Correctly Earlier
- 5.4.13 Devices are not Recognized under Device Manager (Windows* Operating System)
- 5.4.14 Hard Drive(s) are not Recognized
- 5.5 LED Information
- 5.6 BIOS Error Messages
- 6 Warranty