1 removing a hard drive tray from the chassis, 2 attaching a hard drive to the drive tray, Removing a hard drive tray from the chassis – Kontron TIGW1U Carrier Grade Server User Manual

Page 28: Attaching a hard drive to the drive tray

TIGW1U server—Server Installations and Upgrades

Kontron Carrier Grade Server TIGW1U

Product Guide, rev. 1.3

December 2009

3.3.1.1

Removing a Hard Drive Tray from the Chassis

1. Remove the front bezel. For instructions, see

2. Select the drive bay where you want to install the drive. Remove the drive tray by

pressing the green button to open the lever.

Note:

If you will have fewer than three drives installed, drive bay 0 must be used first, then

drive bay 1.

3. Pull the drive tray assembly out of the chassis. (“A” in

)

3.3.1.2

Attaching a Hard Drive to the Drive Tray

1. If a drive is already installed (that is, if you are replacing the drive), remove it by

unfastening the four screws that attach it to the drive tray. (“A” in

Figure 13.

Removing a Drive Tray from the Chassis

TS000218

Figure 14.

Removing a Disk Drive from the Drive Tray

TS000219