CDI Torque MULTITEST Government - Manual (Page 38)

3-8
Setup and Programming
AUTO CLEAR can be programmed with a 1 to 9 second delay.
Use this feature to visually note the reading before the display
clears. AUTO CLEAR with no delay stores, prints and/or clears
with no delay at the initiation of the next torque or force input.
STORE DATA must be pressed to save the last
reading that displays on the LCD after a test.
AUTO CLEAR must be selected to use AUTO
STORE and AUTO SEND.
To use the AUTO CLEAR, STORE, or SEND:
1. Press AUTO CLEAR. LCD display reads:
Figure 3-4: AUTO CLEAR, STORE, SEND Display
2. Use right and left DIGIT to position the flashing (*)
character under the function being changed. To
program:
— CLEAR, press up or down VALUE to select "man"
(manual clear), "auto" (automatic), or (delayed
automatic) from "1Sec" to "9Sec" seconds.
— STORE, press up or down VALUE to select "man"
(manual) or "auto" (automatic).
— SEND, press up or down VALUE to select "man"
(manual) or "aut" (automatic).
3. Press ENTER to return to measurements mode.