Sony SLV-R1000 - Manual (Page 13)

VCR Setup VCR Plus+ Channel Setup
1 Set the RF UNIT on the VCR’s rear panel to CHS or
CH4.
If you made A/V connections, skip this step.
Set to whichever channel is not used in your area.
If both are used, pick either channel.
Details are on page 62.
2 Switch on your cable box.
3 Preprogram the channels into the VCR.
Press MENU. Select TUNER PRESET.
U£NU MENU
»•пметзЕТоссх пмЕЯ8Ег.счеа<
SET UP MENU SET UP MENU
TUNCnPHESCT .TUNEHPaESET
SET VCP Plu». OlANVEl 5 SET VCR Pus-CHANNELS
CA8U£ 404 CWraOL CAaUEBOk CONTAOL
CLOCK 8ET CLOCK SET
Select AUTO PRESET,
then press EXECUTE.
rUNEflPHESET iCHiTi
NORMAbCAtV»NCTM ÈATV
►AUTO PRESET
manual SET «Aoo ERASE
APT «ON
P ine tuning
OPT
Details are on pages 21 and 22.
1 Find the VCR Plus+ Channel Listing in your program
guide. For details, see page 44.
2 For all channels that you want to record, set each
channel to the channel that your cable box uses for
its output (usually 2, 3, or 4), as follows:
Press MENU.
Select SET VCR Plus+
CHANNELS.
MENU MENU
► TIMER SET/CHECK Т1МЕП SETA>C-CK
SET UP MENU SrruPMEMI
TUNS»«NTraer TUNER РЯСет
SET VCR Ptu№ CHANNELS ► SET VCR pup-CHANNELS
CABLE BCW CONTROL CABLE BOX CONTROL
CLOCK SET CLOCK SET
Enter the program guide
channel, then the channel
your ¿VCR uses.
Program listing guide channel-»
Set to the same
cable box channel-
PTUM OfANNEi. UST
GUOe TV*
59 3
ea 3
Your actual cable channel"
Details are on page 45.
09
S
St
To Watch the TV
1 Turn your VCR off, or press the VCR’s TV/VTR button
until the VTR indicator in the display window goes off.
2 Switch on your cable box.
3 Tune the TV to the cable box output channel
(usually 2.3, or 4).
4 Select the channel that you want to watch with your cable
box.
To Watch the VCR
1 Tune the TV to CH 3 or CH 4 (or to A/V input if you made
A/V connections).
2 Insert a cassette and press ► PLAY.
Details are on page 30.
To Record a Program
1
2
3
4
5
Switch on the cable box.
Select the channel you wish to record on the cable box.
Press VCR Plus + on the Remote Commander.
Enter the program’s PlusCode number.
Press ONCE, DAILY, or WEEKLY on the Remote
Commander.
6 Insert a blank cassette.
7 Press TIMER REC on the Remote Commander.
8 Leave the cable box on.
Details are on page 46.
Preparation 13