Dell PowerEdge VRTX - Manual (Page 44)

Figure 28. Removing and installing the power cable retention bracket
1. chassis slots 2. tabs on the power cable retention bracket (2)
3. power cable retention bracket
Removing the wheel assembly
1. Remove any cables routed through the power cable retention bracket.
2. Slide the power cable retention bracket to the right to unlock it.
3. Holding it by the edges, pull the bracket out of the chassis slots and away from the chassis.
4. To reduce the chassis weight, remove the following (if required):
a. Front bezel (if installed)
b. Hard drives. See
Removing A Hot-Swap Hard Drive .
c. Server modules. See Removing A Server Module .
d. Power supplies. See Removing A Power Supply .
5. Lay the enclosure on a sturdy, stable surface with the cover release latch side on top, and the base of the
enclosure extending slightly off the surface edge.
6. Loosen the two screws securing the front and back wheel plates to the chassis.
44