Dell Precision 330 - Manual (Page 78)

78 Installing Upgrades
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
board. For more information, see " EIDE Device Installation
Guidelines ."
b If you are installing a SCSI device, ensure that the SCSI interface
cable is properly connected to the interface connector on the SCSI
controller board. For more information, see " SCSI Device
Installation Guidelines ."
8 Connect a DC power cable to the power input connector on the back
of the drive (see the following figure).
A t t a c h i n g D r i v e C a b l e s ( D e s k t o p C h a s s i s )
9 Ensure that all cables are firmly connected. Fold cables out of the way
to provide airflow for the fan and cooling vents.
10 If the chassis drive bay was previously empty, remove the
corresponding insert from the computer cover.
Hold the cover with the outside facing you. Press the ends of the insert
with your thumbs until the insert snaps free of the cover.
DC power cable
power input
connector
interface cable
interface connector secondary
system board
EIDE connector