Removing a memory module, Installing a memory module, Remove any modules – Dell Precision 330 User Manual
Page 68: Install the upgrade modules
68
Installing Upgrades
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
Removing a Memory Module
NOTICE:
Before disconnecting a peripheral from the system or removing a
component from the system board, verify that the standby power indicator on
the system board has turned off. To locate this indicator, see "
NOTICE:
To avoid damage to the memory module, press the securing clips
with equal force applied at each end of the socket.
1
Press the securing clips at each end of the socket outward
simultaneously until the module pops out slightly from the socket (see
the following figure).
2
Lift the module away from the socket.
NOTE:
If you remove a module (RIMM or CRIMM), you must install another
module in the empty socket before turning on the computer.
Re m o v i n g a M e m o r y M o d u l e
Installing a Memory Module
1
Press the securing clips at each end of the socket outward until they
snap open (see the following figure).
2
Align the slots on the bottom of the module with the two ridges inside
the socket.
NOTICE:
To avoid damage to the memory module, press the module straight
down into the socket with equal force applied at each end of the module.
securing clips (2)