Dell Precision 330 - Manual (Page 72)

72 Installing Upgrades
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
I n s t a l l i n g t h e D r i v e B r a c k e t ( M i n i To w e r C h a s s i s )
8 Connect the interface cable for the drive. See " Attaching Drive Cables
(Mini Tower Chassis) ."
NOTICE: To avoid possible damage, you must match the colored strip on the
interface cable with pin 1 on both the drive and system board connectors.
a If you are installing an enhanced integrated drive electronics
(EIDE) device, ensure that the interface cable is properly
connected to the EIDE connector on the system board. For more
information, see " EIDE Device Installation Guidelines ."
b If you are installing a small computer system interface (SCSI)
device, ensure that the SCSI interface cable is properly connected
to the interface connector on the SCSI controller board. For more
information, see " SCSI Device Installation Guidelines ."
9 Connect a DC power cable to the power input connector on the back
of the drive (see the following figure).
drive/bracket assembly
bracket tabs (2)