Dell Precision 330 User Manual
Page 146

146
Solving Problems
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
•
Check the
to see if the specific problem is
identified.
•
Ensure that a voltage regulator module (VRM) is installed for the
microprocessor.
•
If a
indicated a problem with the microprocessor, the
processor may need to be replaced.
•
Run the System Board Devices and Processor Cache test groups in the
.
•
Reseat the microprocessor.
•
Reseat the VRM.
•
Reconnect the cooling fan for the installed microprocessor.
•
Restart the computer.
If the problem still exists after you complete the basic checks, fill out the
as you perform the following steps.
CAUTION:
Before you perform this procedure, see "
NOTICE:
Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see "
."
1
Run the System Board Devices and Processor Cache test groups in the
.
Did any of the diagnostics tests fail?
Yes.
for technical assistance.
No. Go to the next question.
2
Turn off the computer and devices, disconnect them from their
electrical outlets, and wait 10 to 20 seconds.
3
Lay the computer on its right side.
4
5