Microprocessor, Upgrading the microprocessor – Dell Precision 330 User Manual
Page 101
Installing Upgrades
101
5
Grasp the card by its top corners, and ease it out of its connector.
6
If you are removing the card permanently, install a filler bracket in the
empty card-slot opening, using the screw you removed in
If you need a filler bracket,
and order part number 81808.
NOTE:
Installing filler brackets over empty card-slot openings is
necessary to maintain Federal Communications Commission (FCC)
certification of the system. The brackets also keep dust and dirt out of
your computer.
7
If you removed the AGP brace, replace it.
8
Replace the computer cover, reconnect the computer and peripherals
to their electrical outlets, and turn them on.
NOTE:
option will cause the following
message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
9
If you removed a sound card, perform the following steps:
a
Enter
, select Integrated Devices and change the
setting for Sound to On.
b
Connect external audio devices to the audio connectors on the
system back panel (see "
Back-Panel Connectors and Indicators
").
10
If you removed an add-in NIC, perform the following steps:
a
Enter
, select Integrated Devices and change the
setting for Network Interface Card to On.
b
Connect the network cable to the integrated NIC connector on
the system back panel (see "
Microprocessor
Upgrading the Microprocessor
NOTE:
Dell recommends that only a technically knowledgeable person
perform this procedure.