Dell Precision 330 User Manual

Page 77

Installing Upgrades

To further ensure proper positioning of the drive in the chassis, insert

and tighten all four screws in the order in which the holes are numbered

(the holes are marked "1" through "4").

Slide the new drive/bracket assembly into the drive bay until both

drive bracket tabs snap securely into place (see the following figure).

I n s t a l l i n g t h e D r i v e B r a c k e t ( D e s k t o p C h a s s i s )

Connect the interface cable for the drive. See "

NOTICE:

To avoid possible damage, you must match the colored strip on the

interface cable with pin 1 on both the drive and system board connectors.

If you are installing an EIDE device, ensure that the interface

cable is properly connected to the EIDE connector on the system

drive/bracket assembly

bracket tabs (2)