Dell Precision 330 - Manual (Page 40)

40 Advanced Features
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
NOTE: You cannot change or enter a new system password if either of these
options is displayed.
• Enabled — a system password is assigned
• Disabled — system password feature is disabled by a jumper setting on
the system board
NOTE: You can only assign a system password when System Password is set to
Not Enabled.
• Not Enabled — no system password is assigned and the password
jumper on the system board is in the enabled position (its default)
Assigning a System Password
1 Verify that Password Status is set to Unlocked.
2 Highlight System Password and then press the left- or right-arrow key.
The option heading changes to Enter Password, followed by an empty
32-character field in square brackets.
3 Type your new system password.
You can use up to 32 characters.
As you press each character key (or the spacebar for a blank space), a
placeholder appears in the field. The password assignment operation
recognizes keys by their location on the keyboard, without
distinguishing between lowercase and uppercase characters. For
example, if you have an M in your password, the system recognizes
either M or m as correct.
Certain key combinations are not valid. If you enter one of these
combinations, the speaker emits a beep.
To erase a character when entering your password, press
or the left-arrow key.
NOTE: To escape from the field without assigning a system password,
press or the combination to move to another
field, or press at any time before completing
step 5 .
4 Press .
If the new system password is less than 32 characters, the whole field
fills with placeholders. Then the option heading changes to Verify
Password, followed by another empty 32-character field in square
brackets.