6 if you are permanently removing this drive, A remove the data cable from the computer – Dell OptiPlex 360 (Late 2008) User Manual
Page 72
72
Drives
6 If you are permanently removing this drive:
a
Remove the data cable from the computer.
b
Follow the procedure in "After Working on Your Computer" on
c
Enter the system setup program and navigate to the Drives section.
Under
Drive 0 through 3, set Drive to the correct configuration. For
more information on using the system setup program, see the Dell
Technology Guide on your computer or at support.dell.com
Replacing or Adding a Hard Drive in a Mini Tower Computer
NOTE:
This procedure assumes that you have completed the removal procedure
first.
1 Check the documentation for the drive to verify that it is configured for
your computer.
2 If you are replacing a hard drive, you must first swap the old drive for the
new drive in the existing hard drive bracket (see "Hard Drive Bracket —
Mini Tower Computer" on page 74).
3 Slide the hard drive into the hard drive bay, gently push until it clicks in
place.
1 hard-drive bracket release tabs (2) 2 hard drive
3 hard drive bracket