Dell Inspiron 3700 - Manual (Page 119)

Removing the 12.1-Inch Display LCD Panel
To remove the 12.1-inch display LCD panel, perform the following steps.
NOTICE: To avoid damaging the system board, remove the power cable, the battery, and the second battery (if installed) before you
service the computer.
1. Remove the main battery.
2. Remove the keyboard.
3. Remove the display assembly.
4. Remove the display assembly bezel.
5. Remove the four 5-mm screws securing the LCD panel to the top cover (see Figure 15 ).
6. Disconnect the two-wire backlight plug from the connector on the inverter.
7. Lift the LCD panel and carefully disconnect the flex cable from the connector on the left edge of the LCD panel.
8. Remove the LCD panel from the top cover.
Removing the 12.1-Inch LCD Panel Inverter
1. Disconnect the LCD flex cable from the ZIF connector on the inverter.
2. Remove the three 3-mm screws securing the inverter to the top cover.
3. Remove the inverter from the top cover.
Removing the 12.1-Inch LCD Flex Cable
1 Display assembly bezel
2 Back-light plug
3 Latch
4 Inverter
5 ZIF connector
6 3-mm screws (3)
7 Display assembly top cover
8 LCD flex cable
9 LCD panel
10 5-mm screws (4)
11 Plastic screw covers (2)
12 4-mm screws (6)
13 Rubber screw covers (4)