Backup, Select vm(s) to back up, 7 backup – Acronis Backup for VMware 9 - User Guide User Manual

Page 31: 1 select vm(s) to back up

7 Backup

Click Create Backup Task in the dashboard’s Quick start or Backup in the Actions tab of the main
menu to create a new backup task. The New Backup Task wizard opens in the main workspace area
and asks you to provide the required information and make all necessary settings for the new create
backup task. The wizard consists of the four consecutive steps which appear in the same area:



Select VM(s) to backup.



When to backup.



Where to backup.



How to backup.

These four steps of the wizard and their possible options are described below.

7.1 Select VM(s) to back up

In the first step, you should select the virtual machines (or vApps) which you want to back up. The
left side shows all your ESX(i) host(s)/vCenter managed by Acronis vmProtect 9 Agent with the list of
their virtual machines. If you don’t see the exact virtual machine to back up that you are looking for
in this list, make sure that you have added the corresponding ESX(i) host from the Configure -> ESX(i)
Hosts page.

Select the virtual machines (or vApps) by moving the machines from the left side of the butterfly
control to the right one, via the > and < buttons. The list on the right shows all the virtual machines
selected for backup. The > button is used to add the VM to the backup list, and the < button is used
to remove the VM from this list. You can also select the VM by double-clicking it.

New Backup Task wizard, Step 1 “Select VM(s) to back up”