Removing esx(i) host, 5 removing esx(i) host – Acronis Backup for VMware 9 - User Guide User Manual

Page 104

104

Managing ESX(i) Hosts page, Enter credentials dialog.

15.5.5 Removing ESX(i) host

Removing an ESX(i) host from Acronis vmProtect 9 configuration may be required if you no longer
want to perform backup/recovery operations over the virtual machines running on this ESX(i) host.
The licenses assigned to this host will not be removed automatically. To remove binding licenses, you
have to go to Configure -> Licenses (p. 98) page.

Removing an ESX(i) host/vCenter will cause the existing tasks to malfunction; therefore, when doing
so, you will be prompted with the following warning message:

“You are about to remove an ESX(i) host/vCenter while there are backup or restore tasks associated
with the virtual machines running on this host. These tasks may no longer function properly. Do you
want to continue?”

Choosing Yes will result in the disappearance of all Acronis vmProtect 9 tasks applied to the virtual
machines running on this ESX(i) host/vCenter. If the task included virtual machines from different
ESX(i) hosts, this task will be automatically modified to remove unnecessary virtual machines from
the task configuration. This leaves only the virtual machines which can be managed by the ESX(i)
hosts remaining in registration.