Bio-Rad Model 680 Microplate Reader Accessories - Manual (Page 59)

55
(data length max: 4 characters(include decimal point))
23 Cutoff negative const value
“.001 to 9999”
(data length max: 4 characters(include decimal point))
24 Gray zone “0” to “99”
25 Calibrator concentration value
“0.001 to 9999”
(data length max: 5 characters(include decimal point))
26
Recall setting of Standard
curve [3]
[0] Recall setting: “1”: No recall, “2”: Recall
[1] Recall STD curve number: “1” to “5”
[2] No use: (Default= “1”)
(“ “(0x20) data delimits replicate number.)
27 Number of standard “0” to “12”
28 Standard conc. value[12]
“0.000” to “9999”
(“ “(0x20) data delimits each standard conc..)
(std.value < 1.0: max 5 characters(include decimal point))
(std.value >= 1.0: max 4 characters(include decimal point))
29 Standard unit
“1” to “17”
1:mol/l 2:mmol/l 3:umol/l
4:nmol/l 5:pmol/l 6:mg/l
7:ng/l 8:pg/l 9:ug/dl
10:ng/ml 11:pg/ml 12:U/ml
13:IU/ml 14:uIU/ml 15:mIU/ml
16:EU 17:ARBITRARY
30 Curve fit type
“1” to “10”
1: 5-parameter logistic Rodbard formula
2: 4-parameter logistic Rodbard formula
3: 5-parameter logistic Cook-Wilkenson
4: 4-parameter logistic Cook-Wilkenson
5: 5 Parameter Exponential
6: Sigmoid logistic
7: Linear regression
8: Quadratic regression
9: Cubic spline
10: Point to Point regression
31 Lower limit value Lower limit value (0 to 3500(O.D value *1000))
32 Upper Limit value Upper limit value (0 to 3500(O.D value *1000))
33
Correlation coefficient limit
(kinetic)
Correlation coefficient limit value (0 to 999 (C.C value * 1000))
34
Calculation range start point
(Kinetic) Kinetic calculation range start point reading number (1 to 29)
(This value is lower than calculation start point value.)
35
Calculation range endpoint
(Kinetic) Kinetic calculation range end point reading number (1 to 29)
(This value is big than calculation end point value.)
36 GALT factor value
“0 to 9999.99”
(data length max: 7characters(include floating point))
(A decimal place maximum length is 2.)
37 GALT assay status 0: other assay / 1: GALT assay
38 Kinetic print out report[4]
Kinetic mode Print out report types (0=no print / 1=print)
[0]:Absorbance
[1]:kinetic plots
[2]:Linear regression
[3]:GALT report
39 Print out Report [9]
Print out report types (0=no print / 1=print)
[0]: Raw data
[1]: Absorbance data
[2]: Limit
[3]: Matrix
[4]: Cutoff
[5]: Curvefit
[6]: Difference