Bio-Rad Image Lab™ Software - Manual (Page 31)

Configuring the Imager
User Guide | 31
Configuring the Imager
To use the imager with Image Lab software, the imager must first be configured.
Imager configuration consists of initializing the sample trays and collecting the dark
image.
The imager is configured in the setup wizard, which appears the first time the imager
is connected to a computer.
To configure the imager
1. Turn on the imager and start Image Lab software. The setup wizard appears.
2. Complete the steps in the wizard.
Note: You must complete all the steps in the wizard or the imager will not be
usable.
The first page of the setup wizard
indicates that a new instrument has been
found on the system and displays the
instrument’s serial number.
1. Click Next.