Technical specifications – Bio-Rad Image Lab™ Software User Manual
Page 17
Technical Specifications
User Guide
| 17
Technical Specifications
Hardware Specifications
Image area
15 x 11.2 cm
Excitation source
Trans UV B (302 nm peak)
Detector
Charge-coupled device
Image pixel size
107.8 x 107.8
m (in microns)
Dynamic range
3.0 orders of magnitude
Pixel density
4,096 gray levels
Flat fielding
Yes
Instrument size
43 x 28 x 38 cm
Instrument weight
7.3 kg
Connector descriptions
USB-A connector is used for communication with a PC
USB-B connector is used for the instrument interface
Operating Ranges
Operating voltage
110/115/230/240 VAC Nominal
Operating temperature
10–28
C (21
C recommended)
Operating humidity
< 70% noncondensing
Equipment Ratings
Input voltage range
100–240 VAC
Input frequency range
50–60 Hz
Power
40 W
The Gel Doc EZ imager is for indoor laboratory use only.
Automation Capabilities
Workflow automated
execution
Controlled by a protocol via setup for gel activation, image
capture, analysis, and reporting
Workflow reproducibility
100% repeatability via recallable protocols, from gel activation
and image capture to quantitative analysis and reports
Autoexposure
2 user-defined modes (intense or faint bands)