Installing the drivers on a windows 7 computer – Bio-Rad Image Lab™ Software User Manual
Page 30
2
| Setting Up the Instrument with Image Lab Software
30 | Gel Doc EZ Imaging System with Image Lab Software
A message appears briefly: Your new hardware is ready to use.
Note:
Windows XP might prompt you to go through the driver installation a
second time. If this happens, repeat this section until you receive the message
“Your new hardware is ready to use.”
Installing the Drivers on a Windows 7 Computer
If you are running Windows 7, the device driver is installed during the Image Lab
installation process. After successful installation, you see a message similar to the
following.
Note:
During the installation process you might see a warning similar to the
following. You can ignore this warning because it appears even when the driver
has been installed correctly.