Bio-Rad QX200™ AutoDG™ Droplet Digital™ PCR System - Manual (Page 4)

ii | Automated Droplet Generator ii | Automated Droplet Generator
Safety and Regulatory Compliance
This instrument has been tested and found to be in compliance with all applicable requirements of the
following safety and electromagnetic standards:
■ ■
IEC 61010-1:2010 (3rd ed.), EN61010-1:2010 (3rd ed). Electrical Equipment for Measurement, Control,
and Laboratory Use — Part 1: General requirements
■ ■
EN 61326-1:2006 (Class A). Electrical equipment for measurement, control, and laboratory use. EMC
requirements, Part 1: General requirements
■ ■
UL 61010-1:2004, Laboratory equipment, Test & Measurement Equipment and Industrial Process Controls
■ ■
CAN/CSA 22.2 No 61010-1-04, Safety Requirements for Electrical. Equipment for Measurement,
Control, and Laboratory Use, Part I: General. Requirements
This equipment generates, uses, and can radiate radiofrequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense.
The CE mark indicates that the manufacturer ensures the product conforms with the essential
requirements of the applicable EN directives.
The CSA mark indicates that the product has been tested to Canadian and U.S. standards,
and it meets the requirements of those applicable standards.
This equipment has been tested and found to comply with the limits for a Class A digital
device pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment.
The Waste Electrical and Electronic Equipment Directive symbol indicates that when the end-
user wishes to discard this product, it must be sent to separate collection facilities for recovery
and recycling.
This instrument is for use only by trained personnel.
Do not position the equipment so that it is difficult to operate the plug of the power supply.
The plug of the power supply is the disconnect device.
No serviceable parts inside.