ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 54)

Pressure Depth Sensor and Float Switch Installation 3-31
Installing the Sensor in the Manhole
or Pump Station Wet Well
This section includes the procedure for mounting the pressure depth
sensor to the wall of a manhole or pump station wet well. Install the
sensor in the following way:
1. Gather the parts listed on the following table:
Quantity Description ADS Part Number
1 FlowAlert monitor 6000-FAW or -FAL
1 monitor mounting bracket I40-0003
1 pressure depth sensor with two 4-40 x
5/16-inch stainless steel screws
3704-0010 (5 psi)
3704-0015 (15 psi)
3704-0016 (30 psi)
1 replacement dryer tube 3704-0032
1 direct connection cable 5000-0601
15 11-inch cable tie I05-0003
25 4-inch cable tie I05-0001
15 8-inch cable tie I05-0002
10 anchor cable tie I05-0004
2 ¼- × 2 ¼-inch anchor bolt (with 7/16-
inch nut and washer)
I01-0002
1 3/8- × 2-inch stud I01-0009
1 3/8-inch x 3-inch anchor bolt and nut I01-0003
2 3/8-inch x 1-inch stainless steel hex
bolts
I01-0001
4 3/8 – 16 stainless steel hex nuts I15-0002
5 3/8-inch stainless steel flat washers I55-0001
2 4-40 × 5/16-inch screw I35-0001
8 6-32 washer I55-0002