ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 10)

Introduction 1-5
Installation and Configuration
Following is the general procedure for installing and configuring a
FlowAlert monitoring system. Refer to Chapters 3 through 6 for
detailed instructions and information.
 Investigate the Site Characteristics
 Install the Pressure Depth Sensor
• Assemble the Ring (when applicable)
• Mount the Sensor to the Ring or Special Bands (when
applicable)
• Secure the Sensor Cable to the Ring or Special Bands
(when applicable)
• Install the Pressure Depth Sensor
• Secure the Sensor Cable in the Pipe and the Manhole
 Install the Float Switch(es) in the Manhole
 Connect the Sensor and Float Switch to the Monitor
 Attach the Dryer Tube to the Monitor
 Establish Wireless, Telephone, or On-Site
Communication with Monitor
 Configure the Monitor (using Profile ® Software)
• Create the Monitor Location
• Create the Installation Table (when necessary)
• Select and Edit the Devices
 Set the Communication Parameters (Profile)
 Activate the Monitor (Profile)
 Run Diagnostics and Perform Confirmations (Profile)
 Install the Monitor in the Manhole