ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 202)

In-7
replacing the battery pack, 7-6
ring
assembly, 3-8
installation, 3-18
mounting sensor, 3-16
securing the sensor cable, 3-17
RSSI device
editing, 5-19
S
scrubbing the sensor, 7-9
sensor
confirmation, 7-3
connecting to the monitor, 3-42
editing the pressure device, 5-15
inspection, 7-9
installation, 3-6
mounting sensor to band, 3-23
mounting sensor to ring, 3-16
pressure depth sensor, 3-24,
3-27
ring assembly, 3-8
securing sensor cable ein
manhole, 3-36
special, 3-20
standard, 3-6
wall, 3-31
mounting to the band, 3-23
mounting to the ring, 3-16
pressure depth, 2-9
running pressure depth
diagnostics, 5-32
scrubbing, 7-9
securing cable to the band, 3-29
securing cable to the ring, 3-17
sensors
pressure depth sensor
troubleshooting, 7-20
securing cable in the
pipe/manhole, 3-36
setting communication parameters,
5-20
signal strength, 5-20
editing the RSSI device, 5-19
SIM (Subscriber Identity Module),
4-2
SIM card installation, 4-17
site investigation, 3-4
special installation, 3-20
mounting sensor to the band,
3-23
specifications, A-1
board, A-3
float switch, A-5
lightning protection module, A-6
monitor, A-1
pressure depth sensor, A-4
wireless antennas, B-1
standard installation
mounting sensor to ring, 3-16
mounting sensor to the ring, 3-16
ring, 3-18
ring assembly, 3-8
static IP address, 4-2
Subscriber Identity Module (SIM),
4-2
T
TCP/IP, 5-20
getting address from monitor, 7-4
telephone cable
preparing for connection, 4-26
running between monitor and
service locations, 4-10, 4-23
wiring lightning protection
module to network interface
box, 4-32
wiring to lightning protection
module, 4-30
wiring to monitor, 4-28