ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 167)

7-2 ADS FlowAlert Manual
Maintaining the System Components
The FlowAlert monitor, pressure depth sensor, and float switches
should receive routine on-site inspections and remote confidence
checks to maintain the equipment in optimal working condition,
minimize monitor downtime, and prevent possible data loss.
ADS recommends performing these inspections following initial
system installation, during site visits, and on a scheduled interval
(i.e., quarterly or during battery pack replacement).
Note: The only service or maintenance activity ADS
permits within the monitor chassis is battery pack
replacement. Therefore, please do not handle, alter,
modify, remove, or replace any other components inside
the monitor. This may void the monitor warranty
agreement.
Gathering Replacement Parts and Supplies
Gather the following replacement parts and supplies for performing
routine maintenance:
 Dryer tube for the pressure depth sensor
 Battery pack
 Pressure depth sensor
 Float Switch(es)
 Soft bristle brush
 Paper towels
 Compressed air
 Flat head screwdriver and assorted wrenches (including torque
wrench)