Wing alignment – Great Plains YP2425F-2470 Operator Manual User Manual
Page 96
92
YP2425 & YP2425F
Great Plains Manufacturing, Inc.
401-406M
2014-07-14
Wing Alignment
To check and adjust wing alignment:
1.
Unfold planter. See “Unfolding The YP24” on
page 26. Lower planter. Pull forward.
Refer to Figure 122 and Figure 123
2.
Select a common reference point that is easy to
access at the wing-end and center section end row
units, such as the back of the press wheel
assembly
. On a twin-row planter, align using only
the rear units.
3.
Check for proper alignment by running a string line
across back of planter toward outer ends of wings.
For proper alignment, outside ends of wings
should be 0-to-
1
⁄
4
in ahead of inside ends of wings at
center section
.
4.
To adjust wing alignment, shorten or lengthen eye
bolts
to change the length of the wing pull bar.
Adjust eye bolts in or out until dimension
is
0 to
1
⁄
4
inch (6.4 mm) greater than dimension
.
5.
Be sure both wings are adjusted equally or the
planter will tend to pull sideways behind the tractor.
1
Figure 122
Alignment Reference Point
25193
4
3
2
2
3
4
Figure 123
Wing Alignment
25497
1
2
3
4
2
3