Operating instructions, Pre-start checklist, Operating instructions pre-start checklist – Great Plains YP2425F-2470 Operator Manual User Manual
Page 29
2014-07-14
401-406M
Great Plains Manufacturing, Inc.
25
Operating Instructions
This section covers general operating procedures.
Experience, machine familiarity, and the following
information will lead to efficient operation and good
working habits. Always operate farm machinery with
safety in mind.
Pre-Start Checklist
Perform the following steps before transporting the YP24
to the field.
High Pressure Fluid Hazard:
Relieve pressure before disconnecting hydraulic lines. Use a
piece of paper or cardboard, NOT BODY PARTS, to check for
leaks. Wear protective gloves and safety glasses or goggles
when working with hydraulic systems. Escaping fluid under
pressure can have sufficient pressure to penetrate the skin
causing serious injury. If an accident occurs, seek immediate
medical assistance from a physician familiar with this type of
injury.
❑ Carefully read “Important Safety Information” on
❑ Install seed rate meters appropriate for crop. To
change meters, see “Seed Meter Setup and
Adjustment” on page 75.
❑ Install seed wheels appropriate for crop. To change
wheels, see “Singulator Plus™ Meter Wheel
Replacement” on page 77. With finger meters,
make sure correct 6- or 12-finger units are installed
for the intended row spacing.
❑ Lubricate planter as indicated under “Lubrication
and Scheduled Maintenance” on page 100.
❑ Check all tires for proper inflation. See “Tire
❑ Check all bolts, pins, and fasteners. Torque as
shown in “Torque Values Chart” on page 123.
❑ Check planter for worn or damaged parts. Repair or
replace parts before going to the field.
❑ Check hydraulic hoses, fittings, and cylinders for
leaks. Repair or replace before going to the field.