Great Plains YP2425F-2470 Operator Manual - Manual (Page 23)

Great Plains Manufacturing, Inc. Table of Contents Index Preparation and Setup 19
2014-07-14 Table of Contents Index 401-406M
Electrical Hookup
Refer to Figure 8
Your YP24 is equipped with standard and optional
devices that require separate electrical
connections.Make sure tractor is shut down with
accessory power off before making connections.
These connections may be made in any order.
Note: The switch control module should be mounted in
your tractor cab in a location with easy access.
Route wiring harnesses with enough slack to allow
for tractor movement, especially on articulating
tractors.
Store Main Parking Stand
Refer to Figure 9 and Figure 10
1.
Remove the lower pin and the upper pin
holding the parking stand .
2. Move the stand from under the tongue to an inverted
position in the bracket on the left side on the tongue.
Figure 8
Connector Identification
25236
25237
1
2
Figure 9
Main Parking Stand
26110
2
1
3
1 2
3
Figure 10
Parking Jack Stored
29242
3