Great Plains YP2425F-2470 Operator Manual - Manual (Page 60)

56 YP2425 & YP2425F Table of Contents Index Great Plains Manufacturing, Inc.
401-406M Table of Contents Index 2014-07-14
Height Switch Adjustment
s/n A1062Q+
Refer to Figure 64
Planters s/n A1062Q+ and later include a sensing
switch
that signals the seed monitor (and activates the
optional hydraulic meter drive), when the planter is
lowered for planting. The switch is located at the rear
cross tube on the planter’s left side.
Although factory-preset for typical planting conditions,
Great Plains recommends adjusting this switch for your
exact field conditions and planting depth.
Crushing Hazard:
Exercise extreme caution when adjusting the switch.
1. Lower the planter to the height at which seed
delivery is to begin.
2. Loosen bolt holding switch bracket to plate .
3. Move bracket forward or rearward so that switch
toggle arm
makes contact with rear cross tube .
4. Tighten nuts.
Note: Switch is in “Neutral” position when planting.
Switch is “Activated” when raised.
Figure 64
Height Switch Location s/n A1062Q+
32347
1
2
3 4
5
6
1
2 3 4
5 6