Great Plains YP2425F-2470 Operator Manual - Manual (Page 18)

401-406M Table of Contents Index 2014-07-14
14 YP2425 & YP2425F Table of Contents Index Great Plains Manufacturing, Inc.
Preparation and Setup
This section helps you prepare your tractor and YP24 for
use, and covers tasks that need to be done seasonally,
or when the tractor/planter configuration changes.
Before using the YP24 in the field, you must hitch the
planter to a suitable tractor, inspect systems, level the
planter. Before using the planter for the first time, and
periodically thereafter, certain adjustments and
calibrations are required.
Post-Delivery/Seasonal Setup
On initial delivery, use with a new tractor, and seasonally,
check and as necessary, complete these items before
continuing to the routine setup items:
• Install seed monitor console in tractor (page 140).
• Bleed hydraulic system (page 90).
• Wing leveling and alignment (page 92).
• Marker setup (page 53).
• Radar calibration (page 140).
• De-grease exposed cylinder rods if so protected at last
storage.
Pre-Planting Setup
Complete this checklist before routine setup:
❑ Read and understand “Important Safety
Information” on page 1.
❑ Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
❑ Check that all grease fittings are in place and
lubricated. See “Lubrication and Scheduled
Maintenance” on page 100.
❑ Check that all safety decals and reflectors are
correctly located and legible. Replace if damaged.
See “Safety Decals” on page 6.
❑ Inflate tires to pressure recommended and tighten
wheel bolts as specified. See “Tire Inflation Chart”
on page 122.