Great Plains YP2425F-2470 Operator Manual - Manual (Page 24)

20 YP2425 & YP2425F Table of Contents Index Great Plains Manufacturing, Inc.
401-406M Table of Contents Index 2014-07-14
Storing 3-Point Parking Stands
Refer to Figure 11 (shown without tractor for clarity)
1.
For the standard 3-point hitch, store stands by
either of the following methods:
Remove lower pins . Swing stand under hitch.
Reinsert pin beneath stand at inner hole.
Remove both pins. Invert stand. Re-pin.
2. Adjust the top link of a 3-point long enough so the
ball swivel does not bottom out when fully raised.
3. Secure hoses so they do not get caught in ball
swivel. Failure to do so could cause hose to be
crushed requiring hose replacement.
Tank Cart Hitching
If using a fertilizer cart, consult the cart manual for:
• hitching cart tongue to planter
• connecting pump control electronics to planter
• connecting fertilizer feed hoses to planter
Complete the tractor-planter hook-up before making any
tank cart connections.
Open hose and inlet valves when ready to begin planting.
Close them when not in use.
Fertilizer Connection Types
Figure 11
Storing 3-Point Stands
29732
4
5
4
5
Type Description
2
2-section, planter manifold and pump:
Starter inlet only
3
3-section, cart manifold and pump:
Left, Center, Right inlets & Gauge line
Figure 12
Fertilizer Cart Connections
27372
L
C
R
S
G