Great Plains YP2425F-2470 Operator Manual User Manual
Page 3
Great Plains Manufacturing, Inc.
iii
2014-07-14
401-406M
©
Copyright 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2014. All rights Reserved
Great Plains Manufacturing, Inc. provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been
taken in the preparation of this manual, Great Plains Manufacturing, Inc. assumes no responsibility for errors or omissions. Neither is any liability assumed for
damages resulting from the use of the information contained herein. Great Plains Manufacturing, Inc. reserves the right to revise and improve its products as
it sees fit. This publication describes the state of this product at the time of its publication, and may not reflect the product in the future.
Trademarks of Great Plains Manufacturing, Inc. include: Singulator Plus, Swath Command, Terra-Tine.
Registered Trademarks of Great Plains Manufacturing, Inc. include:
Air-Pro, Clear-Shot, Discovator, Great Plains, Land Pride, MeterCone, Nutri-Pro, Seed-Lok, Solid Stand,
Terra-Guard, Turbo-Chisel, Turbo-Chopper, Turbo Max, Turbo-Till, Ultra-Till, Verti-Till, Whirlfilter, Yield-Pro.
Brand and Product Names that appear and are owned by others are trademarks of their respective owners.
Printed in the United States of America
Table of Contents
Important Safety Information ......................................1
Safety Decals .................................................................6
Introduction ................................................................12
Document Family......................................................12
Description of Unit ........................................................12
Intended Usage ........................................................12
Definitions.................................................................12
Owner Assistance ........................................................13
Product Support .......................................................13
Preparation and Setup ...............................................14
Post-Delivery/Seasonal Setup......................................14
Pre-Planting Setup .......................................................14
Hitching Tractor to Planter............................................15
Hitching with 3-Point.................................................15
Hitching with Hydraulic Tongue (Option) ..................16
Raising/Lowering Tongue.........................................16
Local Float on Hydraulic Tongue..............................16
Hydraulic Hose Hookup................................................17
Protecting Fan Hydraulic Motor Seals ......................18
Electrical Hookup .........................................................19
Store Main Parking Stand.....................................19
Storing 3-Point Parking Stands ............................20
Tank Cart Hitching....................................................20
Fertilizer Connection Types..................................20
Making Fertilizer Connections ..................................21
Heights and Leveling....................................................21
Set Tongue Height ...................................................21
Checking Planter Leveling Side to Side ...................22
Center Section Level Check .....................................22
Wing Leveling...............................................................23
Lock Up Fertilizer Drive ................................................24
Operating Instructions...............................................25
Pre-Start Checklist .......................................................25
Unfolding The YP24 .....................................................26
Raising/Lowering Planter .............................................28
Local Float on Hydraulic Tongue..........................28
Folding the YP24..........................................................30
Transporting the Planter .............................................. 33
Field Set-Up Checklist ................................................. 35
Field Operation ............................................................ 37
Marker Unfolding.......................................................... 38
Both Sides Unfolded ............................................ 39
Monitor Operation ........................................................ 39
Planting ........................................................................ 40
Electric Clutch Operation ............................................. 41
Swath Command™ Clutch Operation .......................... 42
Y-Tubes ....................................................................... 42
Airbox Operation .......................................................... 43
Fan Operation .......................................................... 43
82 bu. Hopper Operation ............................................. 44
Adding Seed to 82bu Hopper................................... 44
Changing the Seed Box or 82 bu. Hopper ................... 45
Checking Planting Rate ............................................... 46
Auxiliary Hydraulics...................................................... 47
Operating Auxiliary Hydraulics ................................. 47
Trailer Operations ........................................................ 48
Short-Term Parking...................................................... 49
Long-Term Storage ...................................................... 50
Adjustments ............................................................... 51
Gauge/Transport Wheel
Adjustments ......................................................... 52
Marker Adjustments ..................................................... 52
Marker Disk Adjustment ........................................... 53
Marker Extension ..................................................... 53
Marker Gauge Wheel Adjustment ............................ 54
Marker Shear Bolt Replacement .............................. 54
Marker Chain Length Adjustment............................. 54
Dual Marker Speed Adjustment ............................... 55
Height Switch Adjustment ............................................ 56