Great Plains YP2425F-2470 Operator Manual - Manual (Page 79)

Great Plains Manufacturing, Inc. Table of Contents Index Adjustments 75
2014-07-14 Table of Contents Index 401-406M
Seed Meter Setup and Adjustment
Your YP24 was originally supplied with a specific seed
meter type and internal components optimized for a
particular crop. Depending on the meter type and
configuration, there may be adjustments available.
You can also entirely change the meter, or swap internal
components, as your crop mix changes. This manual
section assumes that you need to install new meters,
then describes their internal configuration, and finally any
adjustments.
The YP24 planter supports
• Great Plains Singulator Plus™ meters and
• Finger pick-up meters.
The YP24 planter does not support feeder cups. Use a
Singulator Plus™ meter with specific wheels for
volumetric applications.
Meter Removal
1.
Clean out meter. See “Cleaning Out Meters” on
page 93.
Refer to Figure 101
2.
Slide the retaining ring up on the seed hose, and
remove the seed hose.
Refer to Figure 102
3.
Release the lower latch.
Refer to Figure 103
4.
Release the upper latch and swing the drive mount
away from the meter.
Figure 101
Seed Hose Retaining Ring
22883
Figure 102
Lower Meter Latch
22911
Figure 103
Upper Meter Latch
22911