Clover Electronics LCD2084 - Manual (Page 91)

7. Setup
91
7-3.1. HDD WRITE FAIL
If HDD is in full and the OVERWRITE on the HDD is turned OFF in the recording mode, the
system will activate the relay output (See section 5-4.3) for a siren or other device.
▫ Click the HDD WRITE FAIL button in the DISK MANAGER window and select RELAY 1
OUT or DISABLE.
[Fig. 7-26 HDD Write Fail button]
7-3.2. HDD OVERWRITE
▫ Click the OVERWRITE button to select the ON or the OFF. If the ON is selected, the
system continues recording by overwriting start from the first index of the recorded file
even though the space of HDD is in full. If the OFF is selected, the system will stop
recording when the space of HDD is in full.
[Fig. 7-27 Overwrite button]
7-3.3. Format
When you install the new Hard Disk Drives (HDD), it should be formatted before recording.
Formatting is possible only when the system is in the LIVE mode.
▫ Click the “HDD or USB” button to format and then the HDD or USB FORMAT message box
will be displayed (See [Fig. 7-28]).
▫ Click the “OK” button, and you can see the formatting process of the HDD.
▫ Click the “CANCEL” button to return to the Disk Manager.
[Fig. 7-28 HDD FORMAT window]